Distribute VoIP in a room

In most cases requires distribution of voice over IP (VoIP) service for your home not fully you restore your existing telephone lines.

However, before connect to VoIP adapter and call, there are a few steps to take to ensure that your system is to work as expected and not damaged. You need an electrician or a professional network to make these changes. Level of difficulty: Moderately easy

Instructions

You need: screw DriverElectrical band stuff

Isolate the telephone company phone lines

1

Search the interface network (NIU)-unit.

The NUI is the central location where the rows from the input of your home business phone. The NIU is an area which is grey colour generally outside the House.

2

The NUI by open cancel a single screw.

In most cases, you can only access the son, entering your home. Phone company wires coming from the road you can access in General.

3

Drag all screws and terminal connectors and wrap ends with electrical tape.

Do not disconnect the wire to the ground, because it protects your home against lightning.

4

Notify the telephone company that you have disconnected the lines and you should be connected again.

It is an important step because any voltage sent to lines can damage the existing equipment. Leave a comment on the wires or leave a mark on or in the NIU.

5

Close to the NIU and close the screws to sc

hließen.

Service-ser

Distribution lines errors

1

Close existing phone a telephone at home, make sure that there is no service on line.

If you hear a sound or a sound, separately call technicians can check whether all rows correctly are Téléphoneafin company. If you hear any noise on the line, go to the next step.

2

Close your VoIP phone card into any power outlet in your home.

This will run the service in all jacks in your home.

3

Connect the standard phone jacks in your home and your home for VoIP service Wired is.