How to become a fit Internet phone and the phone jack to make

Telephone lines to carry signals and power the phone company in your home, and you can also act as DSL, DSL lines provide Internet connectivity.

Telephone lines, which ends in grey phone RJ-11 with two copper wires. This includes both the DSL signal and the telephone signal on the same cable. You can plug two RJ - 11 telephone jack in parallel grey for the phone and an other socket for the Internet money. Difficulty: average

Instructions

Things you need: RJ-11 PliersWire stripper double Jack crew driver diagonal

1. 1

   Open with NIC or a nest outside of your home.

Drag the modular plug inside makes the disconnects and signs from the telephone company. National immunization days are typically where lines in your home from the position of the telephone utility on the wall closest located.

2

Screw the plate existing your grayscale phone with a screwdriver.

Loosen the terminal screws on the back, disconnect all cables to the grey and remove the grey. 5 Inch from phone wire cut and remove the internal cable from the cable jacket diagonal pliers red and green. Wide band half an inch from the ends of the wires of a cable stripper.

3

Remove the red and green terminal screws both upper and lower actuators.

Wrap yarn green site of green Terminal screw clockwise grey superior and then it's terminal screws at the bottom of the Green grey. Wrap the yarn red needles a clock to the screw to neigtenRed grey superior criminal and place the red terminal screws on lower grey. Establishing a connectiontraining with the bushings color-coded terminals top and bottom creates a parallel connection will allow that distribute two jacks makes and signal same phone line.

4

Drag the phone box

they slowly in the phone output area. Winding wire green needles around the top green Terminal taking screw clockwise and tighten the screw. Wrap the Red wire of the red terminal screw top decision-making and tighten the screw.

5

See the wire and check all connections.

Ensure that all green wires are connected to each other, and that all red wires in the same way are connected. Mounting plate on phone output area with the screws that came with the grey.

6

Close the modular port inside the nest connect your line from the telephone company.

Close all gray phone and search a tone. Place to test a call to the phone line. Disconnect the phone and plug it in others to test the line.

7

Get a RJ-11 telephone cable and close an end to the other.

Plug the other end of the modem to computer cord provided by your telephone service provider. Connect your modem to your network router to your LAN or LAN to enable access to the Internet through your phone line.