As wireless VoIP in a room

In most cases requires distribution of voice over IP (VoIP) service for your home not fully you restore your existing telephone lines.

However, before connect to VoIP adapter and call, there are a few steps to take to ensure that your system is to work as expected and not damaged. You need an electrician or a professional network to make these changes. Level of difficulty: Moderately easy

Instructions

You need: ScrewdriverElectrical band stuff

Isolate the telephone company phone lines

1

Search the interface network (NIU)-unit.

The NIU is the central location where the rows from the input of your home business phone. The NIU is an area of grey color on the outside of the House.

2

Open the NIU cancel a single screw.

In most cases, you can only access the son, entering your home. Phone company wires coming from the road you can access in General.

3

Drag all screws and terminal connectors and wrap ends with electrical tape.

Do not disconnect the wire to the ground, because it protects your home against lightning.

4

Notify the telephone company that you have disconnected the lines and you should be connected again.

It is an important step because any voltage sent to lines can damage the existing equipment. Leave a comment on the wires or leave a mark on or in the NIU.

5

Close the NIU and attach the screws to close.

4 class = "Heading4a" > Service service in loNG distribution lines

1

Close existing phone a telephone at home, make sure that there is no service on line.

If you call a sound or a sound that your tech phone companies listen ensure Ilspermet make sure that all rows are successfully separated.

2

Close all gray VoIP to your phone at home map.

This will run the service in all jacks in your home.

3

Connect the standard phone jacks in your home and your home for VoIP service Wired is.